Installing a B-Square mount on a Browning BPS 20 GA

J

jtheise4

New member
I just bought a B-Square mount for my Browning BPS 20 GA. The instructions say to remove the rear receiver pin. Is there anything I need to be aware of when removing this pin? Should the shotgun be in a specific orientation or is there nothing to worry about??? Thanks.
 
There should not be any issues to worry about and these are usually self center. However, I might suggest you tape the reciever to protect it at any contact point. 3M makes about a 4mil. tape in 2" and 4" widths. This tape is primarly use to wrap and protect piping. It's black. It will also tighten up your saddle fit but should fit just fine. Then at the end of the season, you might want to remove it and clean the reciever. Just make sure your tape is evenly applied to maintain the same thickness. These saddle mounts come with good instruction and are very stable. Just look at your project and let it talk to you. ;)


Be Safe !!!
 
You must log in or register to reply here.
Back
Top