how do you swap out a forend on mossberg 590?

i recieved the compstock a couple days ago and installed the stock no problem. it came with a hogue forend as well and i want to install it. the instructions provided are basically no help. it appears as the mossberg factory forend is molded on? i couldnt find any hardware attaching it, and the hogue does not have any either. if anyone has swapped out thier forend please post up.
 
Wondering the same thing....

I also have a Mossberg and have been trying to find a forend with straps on it for hand support....(not sure I am making myself clear)? Gunssmith at Gander Mt. in Toledo said to contact Mossberg but I have had no luck..
 
With the mag tube off, look inside the forend, you will see a spaner nut. You can use a 1/2 dollar coin to unscrew it if you font have a forend key to remove it.
 
Be sure to get the correct length for the forestock you wish to use...
Comparison of action slide lengths: top 7-5/8”, bottom 6-1/2” Measure from top of threads to bottom of collar that holds the action bars. This measurement is critical to fit when ordering forearms or stock sets that include a forearm. For the most part, 20-year and older sporting shotguns and new tactical shotguns use the 7-5/8” slide. New sporting models have used the 6-1/2” slide for almost 20 years. There are exceptions, however. To be sure, measure! NOTE: Since 2006, most new 500®, 535® and 835® sporting shotguns with synthetic forearms may not use an action slide tube at all; rather, the pump handle will have two integral bars pinned into the handle itself. If you have one of these, you cannot use a forearm that was designed to go over an action slide tube without first buying the correct length tube and action slide tube nut.
From http://havlinsales.com/default.htm
beforeoldstyle.jpg

Funny... my maverick came with the spanner nut fore end:D
Brent
 
Back
Top