Herters revolver ejector tube/rod help

goodolsavage

goodolsavage

New member
Hello, i had purchased a herters rolver made my jp sauer and sohn and its missed the ejector tube and rod and the bushing that goes in the barrel to hold the tube in place.
I was told ruger blackhawk ejectors would work. Does anybody have both that could see. This would be much apreciated

Sent from my LG-H631 using Tapatalk
 
A good close-up of the barrel area would greatly help. You say its missing " the bushing that goes in the barrel to hold the tube in place."

Check to see it the hole in the barrel is threaded or not. If it is threaded, there is no bushing, or stud. You will need a shoulder screw for that. If it is not threaded, then you are missing the threaded lug that attaches the ejector tube.

The lug is silver soldered in place, and that's a pretty touchy job for the gunsmith, as replacing that, if and when one could be found, requires rebluing the barrel.

Not sure about Ruger ejector housings fitting your gun. More than likely check Hawes parts lists schematics.

Bob Wright
 
You must log in or register to reply here.
Back
Top