Handgun Reblueing?

J

JJB2

Moderator
i took my s&w model 27 out last night and spotted a small bit of rust on the side plate :eek: ..... since there are a couple of dings in the finish from the time i dropped it anyway :mad: . i was wondering who had the best deals on refinishing my baby. needs the dings takin out and the blueing redone i guess... i had thought about sending to smith&wesson for a factory job but i need some input on some smiths too. outside of the dings in the barrel and the cylinder and the rust spot about the size of a pin head the thing is in great shape for a 1968 vintage revolver.... ideas?


LIFE IS SHORT.................................................
 
S&W will have the best combination of quality, price, and turnaround.

Plus a genuine factory re-finish is less damaging to the value than a non-factory re-finish.

Plus, while S&W has it, they will check it over for you.
 
YEP D-FERRIS..... i'd have the techs at s&w look it over while was there for sure... i should go over to the smith&wesson website to check on getting it done.... any tips on how to keep a blued gun from rusting ?? i did think it was covered good with rem oil anough to keep it from doing that anyway.



LIFE IS SHORT.........
 
after seeing those reports on the s&w forum i'm really guessing what to do now....... you'd think they might have some really good craftsmen there to work on those old treasures but i guess not......


LIFE IS SHORT........
 
You must log in or register to reply here.
Back
Top