You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Gunscrubber
- Thread starter Joven
- Start date
cntryboy1289
New member
I use it
I haven't found anything on my guns that it bothers so far. I spray it in the chamber and receiver and then wipe the crud off when it runs out.
I haven't found anything on my guns that it bothers so far. I spray it in the chamber and receiver and then wipe the crud off when it runs out.
Desertscout1
New member
There are 2 types of Gunscrubber. The original formula and a new, synthetic-safe formula.
I don't know about ALL frames but original formula is harmless to Glock frames but will quickly soften or melt some plastic grips, spacers, sleeves, etc..
Quite naturally, the synthetic-safe formula reduces or eliminates that.
I don't know about ALL frames but original formula is harmless to Glock frames but will quickly soften or melt some plastic grips, spacers, sleeves, etc..
Quite naturally, the synthetic-safe formula reduces or eliminates that.
On Gunscrubber...
I've used both versions on my HK P2000 and Walther P22 without any problems. It's actually my cleaner of choice for the P22 because to remove the slide after each range trip challenges my manual dexterity. I find I can keep the P22 clean enough to work flawlessly without fully disassembling it for cleaning.
On the other hand I've used Gunscrubber on my S&W 637 and it stripped off the "invisible spray" (read: clear coat) put on my the manufacturer. This was a good thing to me but not everybody agrees. That stuff peeled off like a bad sun burn. With a little help from a soft tooth brush I got the rest of it off. Now I can use Gunscrubber without a worry.
You've probably already figured out that this stuff also removes all trace of lubrication.
I've used both versions on my HK P2000 and Walther P22 without any problems. It's actually my cleaner of choice for the P22 because to remove the slide after each range trip challenges my manual dexterity. I find I can keep the P22 clean enough to work flawlessly without fully disassembling it for cleaning.
On the other hand I've used Gunscrubber on my S&W 637 and it stripped off the "invisible spray" (read: clear coat) put on my the manufacturer. This was a good thing to me but not everybody agrees. That stuff peeled off like a bad sun burn. With a little help from a soft tooth brush I got the rest of it off. Now I can use Gunscrubber without a worry.
You've probably already figured out that this stuff also removes all trace of lubrication.