GP-100 Hammer Rubbing on Frame

R

ReadyOnTheRight

New member
The hammer on my GP-100 is rubbing against the frame on the left side. There is a triangle-shaped mark on the hammer where it rubs against the frame. I can feel it for the first 1/2 of the DA trigger pull -- until the hammer is out far enough that is no longer rubbing.

It's not enough to affect my shooting, it just doesn't have a smooth feel all the way through. The SA trigger pull is awesome.

Any ideas on fixing this?
 
I'm not really that familiar with the way the hammer fits into a Ruger, but one possibility is to use stainless steel bearings (thin washers) to move the hammer out of contact with the frame. Brownell's sells these.
 
The gun is stock from Ruger. I actually like the heavier DA pull.

I think it would be very smooth if I could solve this hammer rubbing problem.
 
hammer rub

My GP 100 and one of my SP101's had the hammer rub problem. I took a dremel tool and just lightly and in several stages opened up the side the hammer dragged on. I couldnt tell you how much metal........other than very little. If you polish of the drag marks on the hammer after each attempt you will see the improvement.
 
You must log in or register to reply here.
Back
Top