Going from 6POS to fixed stock.

[kx592]

Going to convert the collapsible stock to a fixed stock, I have the stock with tube in it already. Is this all I need to make it work?

http://www.bravocompanyusa.com/Rifle-Buffer-M16-AR15-p/buffer rifle.htm

http://www.bravocompanyusa.com/Rifle-M16-Action-Spring-p/spring rifle m16 action.htm

http://www.amazon.com/AR-15-receive...=sporting-goods&ie=UTF8&qid=1328376451&sr=1-1

 

[chris in va]

I think you need a castle nut wrench too.

 

[CTS]

The last item is to attach a sling in single point style I believe (at the rear of the receiver). You should have a standard sling loop on the rifle butt stock, unless you just prefer to use it as a single point style. Also, you should be able to loosen the castle nut with a pin punch and hammer. Just put the punch against one of the notched out areas and tap it loose.

 

[kx592]

I have the wrench, but as far as parts needed, thats all right?

 

[FordV8]

Most fixed stocks have a "rifle" length buffer tube. It is a little longer than the carbine or 5/6 position buffer tubes.

So you will need a "rifle" buffer spring and a "rifle" buffer.

Edit: Doh, I looked at your LINKS after typing. You're GTG!

 

[CTS]

Yep. Should be good to go.

 

[kx592]

Excellent thanks!