FS 1858 Remmy 45 LC conversion

tatso7

New member
Cleaning up the cabinet and need to let go some of the treasures. I fired this gun only ten times with 45 LC cowboy, cleaned, oiled and stored. I have a similar setup in stainless steel so this one has to go. The smeared like appearance on the gun surface is due to the oil reflection.

1858 Remmy ( no BP cylinder )
45 LC conversion cylinder
Slim Jim Holster
Belt.

To your door for $415. Thank you.
 

Attachments

  • rem1.jpg
    rem1.jpg
    74.2 KB · Views: 96
  • rem2.jpg
    rem2.jpg
    85.6 KB · Views: 71
  • rem3.jpg
    rem3.jpg
    49.7 KB · Views: 65
more photos...
 

Attachments

  • rem4.jpg
    rem4.jpg
    90.4 KB · Views: 59
  • rem5.jpg
    rem5.jpg
    34.6 KB · Views: 47
  • rem6.jpg
    rem6.jpg
    83.7 KB · Views: 53
Hate to be a Scrooge but don't let that FFL transfer requirement bite you. This appears to be a class 1 firearm and not a cap-n-ball revolver so "your door" may in fact be "your FFL dealer's door".
 
Clembert is right. Make sure you follow your state and the federal requirements with this revolver. This is no longer a C&B revolver unless you can find a C&B cylinder for it (or perhaps just don't sell it with the conversion cylinder in it). Sell that R&D cylinder separate, even if you sell it to the same buyer.
 
Clembert and Noelf2 - Thanks for the advice. You guys are right. I will have to rephrase the contents of my ad.

Long Rider - I intended to post this at the ad section. For some reason it ends up here. :(

Moderator - Please delete this thread. I will repost this at the appropriate section after revision of its contents. Thank you.
 
Back
Top