So I've had it since Xmas. Been shooting the crap out of it. By far the most accurate rifle I've ever had the pleasure to know. Anyhow about a week ago I was shooting it when the trigger locked up on me. This rifle has the D/E type micro motion trigger. I believe to have solved the issue with said trigger. During fixing trigger while cleaning it I blasted some carb cleaner through it. The action has been bedded. I'm not sure with what/type of bedding. The bedding job was no neat super pro job. It wasnt pretty buy it worked. Rifle was scary accurate. You could see a tiny bit oozed up and out where the stock and receiver make contact. When I initially had the barelled action out to clean trigger you could see that there was a small amount of this bedding adhered to the bottom of the receiver. Intentional or not i dont know.Upon using the carb cleaner most of this bedding I accidentally washed away with the carb cleaner. This could be the problem or at least part of it. I'm not sure how tight to torque the action screws. I may be over or under tightening. I've tried a lot of torque levels and haven't seen any solid improvements. I have also read that issues with these match triggers could cause problems with accuracy. I'm lost and don't really kno what direction to go in now. I won't be giving up. Just saddened and frustrated when it shot so well before and I'm completely ignorant to what went wrong. Please help. Thank you gentleman.