Bucksnort1
New member
About one year ago at a gun show, I got a smoking deal on 250 each, 245 grain, plated, semi-wad cutter bullets manufactured by Frontier Bullets in South Africa. I didn't know anything about Frontier and I didn't inspect the bullets but that didn't make any difference because of the price. I felt I could not go wrong paying $15 for 250 bullets.
Here's the skinny on these bullets. This morning, I loaded 50 with specs for all lead semi-wad cutter bullets. All went well except eight of the seated bullets were lose. On four of them, I was able to turn the bullets by hand to a point where the crimping finally grabbed the bullet. On the other four, I had to re-size, re-bell, re-charge then seat the bullets to the cannelure and add a crimp. These four are now ready, I guess.
I measured the diameter of the bullets and found differences which adds to this problem. Also, plating is not as smooth as Berry's plated bullets and I'm guessing the cast bullet, without plating, is not a high quality bullet.
Considering the price, these bullets are still a good deal and are good for plinking; however, unless I get another smoking deal, I will not buy Frontier bullets again.
Here's the skinny on these bullets. This morning, I loaded 50 with specs for all lead semi-wad cutter bullets. All went well except eight of the seated bullets were lose. On four of them, I was able to turn the bullets by hand to a point where the crimping finally grabbed the bullet. On the other four, I had to re-size, re-bell, re-charge then seat the bullets to the cannelure and add a crimp. These four are now ready, I guess.
I measured the diameter of the bullets and found differences which adds to this problem. Also, plating is not as smooth as Berry's plated bullets and I'm guessing the cast bullet, without plating, is not a high quality bullet.
Considering the price, these bullets are still a good deal and are good for plinking; however, unless I get another smoking deal, I will not buy Frontier bullets again.