For Sale: .220 Swift Brass, Dies, Barrel; RCBS Uniflow Trickler Attachment (Utah)

FrankenMauser

New member
Up for sale: Norma and Winchester .220 Swift brass, .220 Swift RCBS FL dies, Ruger M77 .220 Swift factory barrel, and RCBS Uniflow powder trickler attachment.

The barrel and trickler will be in the second post in this thread.

Shipping is negotiable, but I prefer to use USPS. I live in an area that suffers from poor service with packages, for anything other than USPS Priority Mail (FedEx and UPS should not be considered valid options). First Class mail is acceptable, but may result in a slow shipment.

Cash or Postal Money Order. No GunPal, PayPal, etc.
PM me, if interested. First PM for any given item has priority.
The former .220 Swift is now a .243 Win. So, all proceeds go to the "buy FrankenMauser a swaging press" fund.
Notes (*) are just before the images.

.220 Swift Brass (*):
I am going to be very specific with the condition of this brass. I don't want anyone thinking they received something that was not as described. I know I could sell it faster if listed as "xxx pieces of brass for sale", but I don't want anyone feeling disappointed.
Most of this brass has been deprimed, but not sized. All of this brass has gone through my tumbler, to remove any sizing lube or dirt/grit/grime. Most boxes have reloading data stickers, of some kind, on them.

Norma (boxes of 20 unprimed cases) - (*1)
3 boxes, once-loaded, unfired. $15 / box.
1 box, 17 cases once-loaded/unfired, 3 cases once-fired. $12.

Winchester (boxes of 20 unprimed cases, unless otherwise noted) -
8 boxes, new. $9 / box.
1 box, twice-loaded, unfired. $8. (*2)
2 boxes, once-fired. $8 / box.
1 box of 19 cases, once-fired, one extra case (#20) has a thin neck (outside turned). $7.
1 box of 19 cases, once fired. $7.
1 box of 18 cases, once fired. $6.50.
1 box, twice-fired. $6.50.
1 box of 19 cases, thrice-fired. $5.
1 MTM Case-Guard (R-100) ammunition carrier with 45 new cases, and 42 once-fired cases (segregated into three bagged lots, based on the load fired - bags of 15, 21, 6). All of this brass is from the same lot. (If I find the other bag of 13 once-fired cases, they'll be thrown in for free.) $40.

RCBS 2-Die Set:
Full-length sizer. Includes RCBS #11 and Hornady #4 (not pictured) shell holder. Decapping assembly is the new style with a "headed" decapping pin (one extra pin included). Lock rings have been upgraded (unknown brand - Forster? Old-style Hornady?). $21.


Take it all for $225, with FREE first-class or flat-rate shipping.
(400+ W-W cases, 80 Norma cases, and the dies / shell holders)


*While the rifle was being rebarreled to another cartridge, I pulled-down all of my hand loads. That is the reason for the 'X-times loaded' references, with some of this brass. Most of this brass was purchased between 1983 and 1986.
*1: All of this brass has dark blemishes on the case heads, and a few cases have the blemishes on the case body. It's a surface discoloration of some kind, and did not negatively effect the two boxes of Norma brass (purchased at same time) that were fired and reloaded until failure .
*2: Inherited from my father with a load I didn't trust. Pulled down, reloaded, and never fired with my own load. Pulled down, again, to be sold.

(Using image "collages" to save on the number of uploads needed.)
attachment.php


attachment.php


attachment.php
 

Attachments

  • 220Swift_Collage_800.jpg
    220Swift_Collage_800.jpg
    65.1 KB · Views: 530
  • Brass_Collage_800.jpg
    Brass_Collage_800.jpg
    164.1 KB · Views: 540
  • Brass2_MTM_800.jpg
    Brass2_MTM_800.jpg
    188.5 KB · Views: 538
Ruger M77 .220 Swift factory barrel:
Factory "Varmint" contour barrel. Never re-chambered or re-cut. Good crown. Good throat. Good bluing, with the only nicks/scratches readily visible on the outer diameter of the end of the barrel. Was still shooting beautiful one-hole and clover-leaf groups, when I grew tired of not being able to hunt with the rifle (.24 Caliber minimum).
Should thread right in to any Ruger M77, M77 Mk II, Hawkeye, and most Large-Ring Mausers (large-ring / small-thread Mausers require the threads to be re-cut).
The threads have been oiled, but not cleaned; as I didn't want to expose more bare metal to enable rust.
$70.

RCBS Powder Trickler Adapter:
This is from one of the RCBS 'Trickler System and Powder Measure Stand' kits. I only used the trickler once, but love the stand. Should fit most RCBS powder measures, but I can only guarantee it will fit a Uniflow. -Screws into the bottom of the powder measure, and is adjustable. Allows you to throw a charge into your scale pan, and trickle up to the charge. $13 - Free shipping of my choice.

Take everything listed in these two posts for $300, with FREE shipping of my choice.


attachment.php


attachment.php


Payment methods and other notices in the first post apply here.
 

Attachments

  • Barrel_Collage_800.jpg
    Barrel_Collage_800.jpg
    163.9 KB · Views: 515
  • IMG_1439_800.jpg
    IMG_1439_800.jpg
    87.9 KB · Views: 508
The barrel has been sold.

The rest should still be available.

I sent you a PM, and I'll send another after I re-inventory the remaining brass, dies, etc.
 
Back
Top