Fixing CZ75 trigger pin?

A

AndABeer

New member
I know this has been covered before but the search function wont let me use words less than four letters such as "pin" and "CZ" so I am forced to just ask the question again.

The trigger pin on my CZ75B has taken to working itself free during firing sessions. I can wiggle it back in place easy enough but am wondering how to cure the problem rather than the symptom. So, suggestions?
 
Hello. Had this problem a few years ago. Ease the pin out a bit using a similar sized punch to act as a slave pin. You don't need to go out anymore than the thickness of the frame on either side.
Degrease the pin and put a bit of "Gun-Tite" or Lok-Tite (Blue) on the pin and reinsert it. Should that not work (I think it will), the pin can be completely removed and slightly bowed and reinserted.
If you do this, be sure to have a punch that is the same size or make a "slave pin" the same size as the pin you're working on so that you don't have to take out the trigger/spring assembly as it's a little tough to get back in.

Best.
 
I have the same problem a few weeks back and I went with the blue locktite. The pin hasn't moved 300 rounds later.:)
 
You must log in or register to reply here.
Back
Top