britonleap
Inactive
Hi, Everyone!
I recently got a Browning XS Skeet with a satin finish on the stock. I love the gun, but there are some small dings on the stock. Those aren't bad, but there's also a little deformation where the stock meets the butt-plate (it was shortened) that really needs a light sanding.
I have a short LOP so this actually gun fits me pretty close, after adding a Jones adjustable plate to it. (Using it to shoot trap!)
I'm not ready to completely refinish the stock. I'd like to make it a little nicer though. Can anyone confirm that this is a satin polyurethane finish? Such as a spar varnish?
I think I can lightly sand, add a drop to the dings, sand, wet sand and polish this back up, then satin it down with some 0000. But I'd sure like to hear from some of you who have worked with these.
Thanks in advance for any advice!
I recently got a Browning XS Skeet with a satin finish on the stock. I love the gun, but there are some small dings on the stock. Those aren't bad, but there's also a little deformation where the stock meets the butt-plate (it was shortened) that really needs a light sanding.
I have a short LOP so this actually gun fits me pretty close, after adding a Jones adjustable plate to it. (Using it to shoot trap!)
I'm not ready to completely refinish the stock. I'd like to make it a little nicer though. Can anyone confirm that this is a satin polyurethane finish? Such as a spar varnish?
I think I can lightly sand, add a drop to the dings, sand, wet sand and polish this back up, then satin it down with some 0000. But I'd sure like to hear from some of you who have worked with these.
Thanks in advance for any advice!