Finally got a MOA group with Barnes

ligonierbill

New member
I've been working these in several calibers, but never could get a really good group. Last week I had high hopes for the 120 TTSX in my 6.5x55, but...2" at 100. Not the rifle; it shoots 120 Nosler BT at 1/2". So my expectations were not high yesterday when I took out my .338 WM with some 210 TTSX. First three went in the same hole! Should have taken a picture, but I sent two more that both fell within an inch. I was taking my time, but the barrel was warming up nonetheless.

Looks like my go to "lite" load for this cannon, especially given Barnes reputation for terminal performance. It has noticeably less recoil than the 250 SGK (worked a new load with VV N560 right after shooting the group). BTW, the 250's fell within an inch and a half at Vihtavouri's max load. This is a Savage 116 "Weather Warrior". Oh, I use one of those stick in your shirt gel pads. No bruises after 25 from the bench. Like this rifle.
 
Have you been seating your Barnes bullets far enough off the lands? I haven't tried them yet but reportedly, Barnes copper bullets REALLY like to jump.
 
I've just been loading to the COL from Barnes' data. Obviously that was the right length for the. 338, but I should work it for the Swede. Just started working with the 80 grain TTSX in the. 243, so I'll keep that in mind.
 
Had to follow up on my .243 Win loads with Barnes 80 gr TTSX - another super group. Four in one hole, and the fifth within an inch (my fault, I think). Guess I should go back and play with the length on the 6.5. I'll be shooting this .243 load for deer season.
 
Don't know. I just loaded to Barnes' 2.61 and hit it right, as I did with the .338. Guess I'll have to work for the 6.5, though, loading an inert round, etc.
 
I've only used one, the 7mm 150 grain TTSX in a 7mm Remington Magnum. Quite simply, the most accurate bullet ever fired out of that rifle. There have been other bullets that did quite well, but none that have bested the TTSX.
 
Back
Top