Can anyone tell me how (if its possible) to adjust elevation (higher) on my scope rings? I recently bought a new scope for my 10/22 and with the scope set at "0-0" it is shooting about a 1-1/2feet low at 25yds. I am able to make internal elevation adjustments with the scope. However, with the rifle zeroed at 50yds it does not allow me much more room to adjust elevation "up" for 100-150yds. I have finger adjustable turrets (1/8MOA) on my scope. According to the instructions that came with the scope, it states that "if more than a few turns are required to internally adjust to zero the scope...a qualified gunsmith may need to make mounting adjustments in order to get the most out of it".
I have rings made by "Millet". I noticed that it came with what looked like strips of tape. Do these strips go inside the rings for minor external adjustments? Also would this provide unecessary torque on my scope?
Any help would be appreciated,
WinMag
I have rings made by "Millet". I noticed that it came with what looked like strips of tape. Do these strips go inside the rings for minor external adjustments? Also would this provide unecessary torque on my scope?
Any help would be appreciated,
WinMag