ejector mechanisms

W

williamd

New member
:confused: Purchased a Rem 3200 (12g, obviously) and a Winc 101 (20g). Previous owner had removed ejector mechanisns from forearms and they are long gone ... as is he. I would like to replace. Any reasonable price. Also posted under shotguns.
 
If you are looking for the cost of a gunsmith installing the ejectors you should get in touch with local gunsmiths. If its difficult for you to find some call the manufacturers for a price. You can also get prices from gunsmiths all over the country by posting on www.trapshooters.com They will surely answer your query. If you want to get the parts from the manufacturer, go to Barnes & Noble get the gunsmithing books pertaining to your problem check the diagrams and installation instructions and do it yourself. Hope this helps and I hope I understood what you wanted.
 
Did he take out the whole "mechanism" or just the ejector springs?
A little study there could save a lot of money for parts and installation.
 
This time, unfortunately, the entire mechanism is removed from the forearm!
I have unistalled/installed the ejector mechnaisms on several guns so that is not a problem. This essentially turns the guns into extractor models that some folks prefer. Or, for folks who have tubes for their 3200.
I have removed the ejector springs on several 3200s for folks who fear the common cracking of the forearm on these fine guns. Can be solved by careful drilling and pinning with fine steel or bamboo and Acraglass (or other .. suspect Gorilla Glue would work).
 
You must log in or register to reply here.
Back
Top