Joe Portale
New member
Hello folks,
Is it possible to turn down the threades on a barrel intended for a large ring action to accomidate fitting to a small ring action? I know that the large ring action ID is 1.1 inches and the small ring is .98. Both are threaded to 12 TPI. It seems reasonable given the .03 difference between the two action types. If it this is doable, is there anything that may need to the barrrels torque shoulder?
Thanks.
------------------
Joe Portale
Tucson, Arizona Territory
"Those who turn their swords into plow shears,
end up plowing the fields of those who didn't"
Thomas Jefferson
Is it possible to turn down the threades on a barrel intended for a large ring action to accomidate fitting to a small ring action? I know that the large ring action ID is 1.1 inches and the small ring is .98. Both are threaded to 12 TPI. It seems reasonable given the .03 difference between the two action types. If it this is doable, is there anything that may need to the barrrels torque shoulder?
Thanks.
------------------
Joe Portale
Tucson, Arizona Territory
"Those who turn their swords into plow shears,
end up plowing the fields of those who didn't"
Thomas Jefferson