.22rimfire
Inactive
hey I just wondered how much it would probably cost to get my rifle drilled and tapped for scope mounts its a remington 510 targetmaster 22 and I have a gander mountain near me
drill and tap
- Thread starter .22rimfire
- Start date
thedaddycat
New member
I've never had it done but if you call Gander, Dick's sporting goods or a local gunsmith they should be able to tell you. I think it's a pretty standard service with a set rate for normal installations. I know that the last time I was in Dick's they had it listed at the gun counter but don't recall what the price was.
I have d&t'ed a lot of Rem 510s, but I am not a gunsmith.
The chart for Rem 510 says
http://www.brownells.com/.aspx/lid=11875/guntechdetail/Weaver_Top_Mount_Bases
#42 Weaver in the front and a #43 Weaver in the rear.
I would suggest, instead, using two #43 mounts or bases as Brownells calls them, on the receiver.
The chart for Rem 510 says
http://www.brownells.com/.aspx/lid=11875/guntechdetail/Weaver_Top_Mount_Bases
#42 Weaver in the front and a #43 Weaver in the rear.
I would suggest, instead, using two #43 mounts or bases as Brownells calls them, on the receiver.
