Hey all, couple of questions. Wanting to get a DMPS multitool and receiver vise clamp. Any in particular you guys would recommend? I'm trying not to break they bank here so cost is a consideration.
The other question I have is, for minor scratches and such on matte black anodized metal which is better, Birchwood Casey Aluminum black, or Aluma Hyde? Haven't seen too many side by side comparisons.
When removing a barrel nut from an DPMS AR-15, do I have to heat it up to remove any locktite that might have been used, or do they not use locktite on that part of the gun?
Also what is the barrel torque for the barrel nut? I've seen 30lbs but would like to verify that.
Thanks.
The other question I have is, for minor scratches and such on matte black anodized metal which is better, Birchwood Casey Aluminum black, or Aluma Hyde? Haven't seen too many side by side comparisons.
When removing a barrel nut from an DPMS AR-15, do I have to heat it up to remove any locktite that might have been used, or do they not use locktite on that part of the gun?
Also what is the barrel torque for the barrel nut? I've seen 30lbs but would like to verify that.
Thanks.