jackstrawIII
New member
Hey,
My friend bought a 750XL and I'm helping him get it set up. After MANY hours of setup, we're finally making some 38 special plinking rounds.
That said, we have two issues, both relating to primers:
1. About 10% of the time it's not removing the old primer. 90% of the time it works fine... but sometimes it doesn't. I cannot understand how this is possible. It seems like it should always work, or always not. Any ideas?
2. The primer seating depth is ALL OVER THE MAP. I started pulling the handle fully down, then pushing it fully forward... but it's still not seating all the primers all the way. Sometimes it does... other times it doesn't. Again, I'm just confused. Is there some setting or something I missed in the 4,000 steps it took to set this thing up?
Appreciate any ideas. Thanks.
My friend bought a 750XL and I'm helping him get it set up. After MANY hours of setup, we're finally making some 38 special plinking rounds.
That said, we have two issues, both relating to primers:
1. About 10% of the time it's not removing the old primer. 90% of the time it works fine... but sometimes it doesn't. I cannot understand how this is possible. It seems like it should always work, or always not. Any ideas?
2. The primer seating depth is ALL OVER THE MAP. I started pulling the handle fully down, then pushing it fully forward... but it's still not seating all the primers all the way. Sometimes it does... other times it doesn't. Again, I'm just confused. Is there some setting or something I missed in the 4,000 steps it took to set this thing up?
Appreciate any ideas. Thanks.