PolarFBear
New member
Loading Winchester brass, 45ACP. Not from same lot, # of firings unknown. Loaded 10, using CCI primers, all OK. Next one in the primer feed "felt" OK but the primer was just a touch pround. I then prepped all primer pockets on a Lyman case prep machine, never had to do this on pistol brass before. Did find some primer holes (not the pocket just the flame hole) a bit large and discarded that brass. Cleaned the primer mechanism on the press with a brush and canned "air". Tried again and still primers are standing "pround" by a couple of thousandths. Any Dillon "pros" on site? Directions to a Dillon website? I've loaded quite a few rounds over the years on this press. Never any real problems: 'til now.
Last edited: