Deposits from Black Bullets P/L HI-TEK coating ?

R

RickCoop

New member
Hello all, I have just purchased an evaluation pack of 9mm 125gr. bullets from Black Bullets International and have a few questions before shooting them. Black Bullets web site says they use P/L HI-TEK coating. Has anyone used these bullets? Do they leave deposits of that coating in your barrel? If so, were you able to remove it and what did you use? My current go to load is a 124gr Xtreme copper plated under 4.2gr of Bullseye but I am looking into some alternatives to the plated bullet. Is anyone out there using the Black Bullets and could you share your experiences?
Thanks
Rick
 
I've used the BBI and Bayou bullets with the hi-tek coating, both are good to go, provided you're not using a superhot powder (TG, for example) that burns through the coating.
 
I've used 3.6gr of titegroup exclusively for 135gr bayou in 9mm. I'm almost at 3k rounds fired of them, through a g19, shield, p229, and a sp2022. I have not had any leading or hitek deposits.
 
You must log in or register to reply here.
Back
Top