Well I tried the product made by shooting champion David Tubb called Final Finish. It is made for people that reload and want to smooth out their bores for better velocities, less fouling easier cleaning and better accuracy. It's something like a fire lapping but a little different. You get 75 bullets of 5 different levels of courseness which are coated almost like a moly coat. You will only shoot 50 the first time you do this treatment on a factory bore, less on a custom barrel(there are special instructions for these). The others you save for the future when your barrel needs a little touch up like when your throat is getting a little long. You load the rounds and shoot from the coursest to the finest coated rounds cleaning between each of the 10 round strings. Some might say this sounds like a barrel break in thing and to a point it is but you can do this on any rifle and believe me the benefits are great. I used it on my factory Remington 700P 300WinMag that fouled like no other rifle I've owned. It was also a bear to clean. I had already done some load testing so I had some velocities from the chrono to check the new velocities against.
They say that it will give you greater velocities, less fouling, easier cleaning and better accuracy. It does! My velocities with the same loads went up 60FPS! My primers were just starting to flatten with this load before the treatment but after there wasn't a hint of pressure signs so the pressure must have dropped also from the bore being smoother. Also noted was that there was barely any fouling to be had and the cleaning took no time at all. Accuracy on the other hand was just a hair better but with the other benefits that's fine with me. If you are interested and want to read some more go to www.zediker.com This is where I bought mine from. For about $35 it was well worth it especially on a factory barrel. If you load your own give it a try. You won't be sorry.
They say that it will give you greater velocities, less fouling, easier cleaning and better accuracy. It does! My velocities with the same loads went up 60FPS! My primers were just starting to flatten with this load before the treatment but after there wasn't a hint of pressure signs so the pressure must have dropped also from the bore being smoother. Also noted was that there was barely any fouling to be had and the cleaning took no time at all. Accuracy on the other hand was just a hair better but with the other benefits that's fine with me. If you are interested and want to read some more go to www.zediker.com This is where I bought mine from. For about $35 it was well worth it especially on a factory barrel. If you load your own give it a try. You won't be sorry.
