I have an old VZ-52 rifle with a rusted out bore. I want to install a spare barrel that I have. I've removed the barrel retaining pin.
How should I proceed from here? I think the barrel is press fit. I was thinking of using a large brass bar and heavy hammer to break it loose but the rear end of the receiver gets in the way. Seems like it would also be a problem if trying to use some type of barrel press.
Any suggestions?
Thanks!
How should I proceed from here? I think the barrel is press fit. I was thinking of using a large brass bar and heavy hammer to break it loose but the rear end of the receiver gets in the way. Seems like it would also be a problem if trying to use some type of barrel press.
Any suggestions?
Thanks!