glockorama
New member
I recently recieved 2 82's from AIM. They are both in excellent condition, looking brand new.
Unfortunately, during the 1st range session, a few problems arose.
One gun had the now infamous missing slide release spring. Had it before shooting, lost it somewhere during. Have ordered a few new springs from Norm
Sutton, so, hopefully, that will be rectified soon.
The bigger head-scratcher is on pistol #2; it shot fine and dandy at the range (great shooting guns and quite accurate), however, after getting it home, the hammer does not always release when the trigger is pulled in DA. If I pull the DA trigger REALLY fast it usually trips the hammer, but if I pull it slowly, or even normally, the trigger will go fully to the rear, as will the hammer, but the hammer will not fall. If I release the trigger a bit forward, the hammer usually falls (but not at any time during the initial pull back). SA trigger releases just fine.
Any thoughts?
Unfortunately, during the 1st range session, a few problems arose.
One gun had the now infamous missing slide release spring. Had it before shooting, lost it somewhere during. Have ordered a few new springs from Norm
Sutton, so, hopefully, that will be rectified soon.
The bigger head-scratcher is on pistol #2; it shot fine and dandy at the range (great shooting guns and quite accurate), however, after getting it home, the hammer does not always release when the trigger is pulled in DA. If I pull the DA trigger REALLY fast it usually trips the hammer, but if I pull it slowly, or even normally, the trigger will go fully to the rear, as will the hammer, but the hammer will not fall. If I release the trigger a bit forward, the hammer usually falls (but not at any time during the initial pull back). SA trigger releases just fine.
Any thoughts?