I got this $26.00 tool case from Lowes. It's a nice aluminum case with a foam bottom and a Compartmentalized tool flap behind the top foam layer inside the lid.
The foam in the bottom half was not very solid, so I went looking for a replacement.
I found
www.foamsweetfoam.com
They cut me two pieces the size of the case, one 1.75 inches think and one .75 inches thick.
I put the 1.75 inch piece down and then laid my guns out on the thinner piece. After outlining everything, I cut the pieces out with an electric carving knife.
The result is still a bit rough, but I have spare pieces of foam to work with and it's still a lot better than what it was. I now have a decent transport/presentation case for my little friends for a total cost of $40 or so...
The foam in the bottom half was not very solid, so I went looking for a replacement.
I found
www.foamsweetfoam.com
They cut me two pieces the size of the case, one 1.75 inches think and one .75 inches thick.
I put the 1.75 inch piece down and then laid my guns out on the thinner piece. After outlining everything, I cut the pieces out with an electric carving knife.
The result is still a bit rough, but I have spare pieces of foam to work with and it's still a lot better than what it was. I now have a decent transport/presentation case for my little friends for a total cost of $40 or so...