$300 gun show 6-23-2012 May 1963 Rem700 ADL with Hart 7mmRM stainless painted black barrel.
$230 Shilen stainless match #3 taper barrel brownells 9-18-2012
$232 High Tech Specialties [Bansner] stock brownells
$435 L4 VX-III 3.5-10x40mm. Matte, standard duplex, CDS, 24HCF 3-16-2013
$50 Burris low tactical rings brownells
$40 EGW one piece base swfa
$35 Holland recoil lug and pin brownells
$32 Large grind to fit Limbsaver recoil pad brownells
$36 Vero Vellini sling V19023 amazon
$30 rear bag dog-gone-good Holland type 2x3x4" direct
$12 Uncle Mikes 1" swivels amazon
$14 Allen buttstock cheekrest shell holder pouch amazon
$9 glow tape JVCC GLW, Amazon Oct 2, 2013
$10 one part epoxy spray paint ALUMA-HYDE II AEROSOL, O.D. GREEN brownells
sharpie marks on tape for ranges
5/8 round Aluminum for pillars Enco 1/2" 6' RND ALUM ROD6061
Pine for butt plug to attach recoil pad
screws for recoil pad
Devcon steel putty for butt plug, pillars, and recoil lug
ammo
bore cleaning
rifle case
7mmRemMag reamer
Lathe bits
-------------------
$1572
At 477 yards in Oct 2013 I shot a buck exactly on the shoulder where I was aiming with that rifle.
I wrote an email to Darrell Holland about the distance between centers [that looked like between 0.605 and 0.608" for me to drill my receiver to pin his newer thicker recoil lug. I was replacing the old ragged rusty recoil lug. I got an answer in 5 minutes.
BestRifles@aol.com via mx.aol.com
Clark, the dimension is .605... Good measuring...
Go forth and do GREAT things, check out our stocks muzzle brakes etc.
Thanks
Hollands
Pic of dead deer and rifle below