I've got a Dan Wesson 15-2 target wheel gun. Most of the shells I shoot through it, including factory loads are extra hard to eject from the cylinder. It has to be that the sizing of the cylinder is either to large or too small. I believe that it is two large causing the casings to swell under pressure. If it is too large I'll need to replace the cylinder. Too small maybe I can get it resized by sanding the inside? Any suggestions?
Thanks,
------------------
Richard
The debate is not about guns,
but rather who has the ultimate power to rule,
the People or Government.
RKBA!
Thanks,
------------------
Richard
The debate is not about guns,
but rather who has the ultimate power to rule,
the People or Government.
RKBA!