cap screws loose
- Thread starter cw308
- Start date
Just to help you out, so you get somebody to post a real expert analysis about why this certainly COULD happen I'll step up and post my definitive reply:
No. No this could not happen.
This will trigger someone's reply that if the scope was slightly damaged loosening or tightening the cap screw would affect the scopes point of aim. Or they'll point out how some garbage inside of the cap screw was actually turning the scope setting screw when you tightened it and loosened it but since it changed the setting screw the EXACT same amount when you took the cap screw off the setting looked the same and you'd have no idea that it was being changed by loosening and tightening the cap screw.
The firearm world is just too darn plain goofy to say 'never' and 'always'.
No. No this could not happen.
This will trigger someone's reply that if the scope was slightly damaged loosening or tightening the cap screw would affect the scopes point of aim. Or they'll point out how some garbage inside of the cap screw was actually turning the scope setting screw when you tightened it and loosened it but since it changed the setting screw the EXACT same amount when you took the cap screw off the setting looked the same and you'd have no idea that it was being changed by loosening and tightening the cap screw.
The firearm world is just too darn plain goofy to say 'never' and 'always'.
Its not the turret cap. I loosened the screw about a year ago when zeroing the cap on a 200 yard zero. Just happen to check the setting screws & both were pretty loose , my click zero was the same. Wondered if a little wiggle would happen causing groups to open up. I guess I'm looking for another excuse.
Pahoo
My scope zero settings didn't move on the scope, the caps both windage & elevation were both loose but in position. I tighten the screws, will see if groups get a little tighter. Once I zeroed at 200 yards, depending on the temperature the groups were higher or lower, I never changed the scope setting. Only went for grouping. Just happened to remove the turret caps ,when I noticed both were loose. Just another thing to check .
My scope zero settings didn't move on the scope, the caps both windage & elevation were both loose but in position. I tighten the screws, will see if groups get a little tighter. Once I zeroed at 200 yards, depending on the temperature the groups were higher or lower, I never changed the scope setting. Only went for grouping. Just happened to remove the turret caps ,when I noticed both were loose. Just another thing to check .
Interesting !!!
Be Safe !!!
Well, looks like I missed it again. Don't run into this problem, very often and the last time I can remember, It was just the elevation adjusting post that was effected. It was on a cheap scope that I was helping a friend with. I knew that it was not an ideal and in the end, it did effect the point of aim. I think that he is still living with it, as is. Normally you will have this happen when you have exceeded the travel range of the adjustment. ......
Be Safe !!!
Pahoo
Its a Bushnell 6x24x40 $ 300. Scope. The ranges on LI, NY are max. 200 yards. Most of the guys I shoot with have higher end scopes, 500 to 2500 but for once a week shooting at 200 yards my scope serves me well. I will see tomorrow if the groups tighten after tightening the screw.
Its a Bushnell 6x24x40 $ 300. Scope. The ranges on LI, NY are max. 200 yards. Most of the guys I shoot with have higher end scopes, 500 to 2500 but for once a week shooting at 200 yards my scope serves me well. I will see tomorrow if the groups tighten after tightening the screw.