bullet feeders, budget friendly, need help...

S

Shadow9mm

New member
Ok, I am looking at 2 options, a case feeder or bullet feeder, not both. Due to my current loading setup, I am heavily leaning towards a bullet feeder.

It will be going on my Hornady Lock N Load press.

I have been doing a little looking, but bullet feeders seem to be a lot more expensive, and require a lot more expensive changeover kits.

Looking to do 223 and 9mm

My budget it about about $400.
 
With a 3d printer, you can make most of your own. Then of course, there's the people selling the 3d printed one. For me, the case feeder is the more valuable of the two. With a bin of bullets in the right spot, I can grab the next bullet and get it oriented and in the case, just about as fast as I pull the handle. Probably takes a second and a half or so each cycle of the handle. Because of that, I see little benefit to finishing my bullet feeder

Sent from my SM-G996U using Tapatalk
 
You must log in or register to reply here.
Back
Top