My old Buck Mark Bullseye (circa 1996) has got ... I don't know ... 20K through it, maybe? It's been very reliable to this point, but now I'm running into one or two FTEs per box.
I've got it apart and the tension on the extractor is good. But the ejector is rather wobbly. It moves enough that it drags on both the top and side of the clearance slot in the breech face. Apparently this has been going on for a while, as there's a wear pattern on the ejector itself.
So I'm thinking a new ejector is in order - and I have a new one on hand. But how do I get the old one out - and then the new one in? None of the schematics I have show this level of detail. The ejector appears to sit in a slot, where it's subsequently staked. Is that all there is to it?
Does anyone have firsthand experience with this?
Again ... I need help with the ejector ... the stiff wire that hits the cartridge in the butt when the slide moves back. The extractor (aka claw) is fine.
Thanks,
dogfood
I've got it apart and the tension on the extractor is good. But the ejector is rather wobbly. It moves enough that it drags on both the top and side of the clearance slot in the breech face. Apparently this has been going on for a while, as there's a wear pattern on the ejector itself.
So I'm thinking a new ejector is in order - and I have a new one on hand. But how do I get the old one out - and then the new one in? None of the schematics I have show this level of detail. The ejector appears to sit in a slot, where it's subsequently staked. Is that all there is to it?
Does anyone have firsthand experience with this?
Again ... I need help with the ejector ... the stiff wire that hits the cartridge in the butt when the slide moves back. The extractor (aka claw) is fine.
Thanks,
dogfood