T Tido4570 New member Mar 13, 2010 #1 I have a browning bps 10 gauge that I would like to take the stock off of. The recoil pad has no holes to get the screws out. Any help? Thanks, Steve
I have a browning bps 10 gauge that I would like to take the stock off of. The recoil pad has no holes to get the screws out. Any help? Thanks, Steve
T Tombstonejim New member Mar 13, 2010 #2 I bet if you take a little spray cleaner and clean the pad good and then look where you think the holes ought to be you will see a tiny slit just big enough for a round screwdriver to fit threw. The slits are made with a razor knife.
I bet if you take a little spray cleaner and clean the pad good and then look where you think the holes ought to be you will see a tiny slit just big enough for a round screwdriver to fit threw. The slits are made with a razor knife.
H hoghunting New member Mar 14, 2010 #3 Squeeze the sides of the pad together and the slits will raise up.
S Scorch New member Mar 14, 2010 #4 And lube the blade of the screwdriver before you put it into the holes to loosen the screws.
