Browning BAR assembly problem

J

jsl1952

Inactive
Had a small glitch on reassembling the rifle, I installed the trigger assembly, did not dissamble just visual this assembly, I then installed the stock plate and I think this is my problem, I inadvertenly drew the bolt back not knowing the stock plate had fallen into the receiver out of its position, the bolt drew back and stuck, will not go either way, the stock plate does have a little play but not enough to get it repositioned. I downloaded a copy off of Midwestern that was better than the factory manual but didn't have a tip on this, any help on this ?
 
BAR Reassembly

Thanks for the link on the video, I believe I noticed the problem, will find out this evening, good luck on your 2012 project .....

PROBLEM FIXED - When I pulled the bolt back, shouldn't do this without the stock on, the rear upper part of the bolt assy jambed with the stock plate, a little finesing & she came loose
 
Last edited:
You must log in or register to reply here.
Back
Top