better Remington 700 spring needed

M

Magnum Wheel Man

New member
my 6.8 Remington 700 project is nearly done... the rifle is together but only feeds marginally right now... 1st & last rounds always feeds, but 3rd round never feeds...

the rifle was originally chambered in 22-250, I bought a Remington 6.8 magazine box from gun parts corp. & used a spare 17 Remington follower, & mag spring... the stock Remington springs for the short actions, often tip the front of the follower down, & do so on this one... my builder buddy thinks this is likely the cause of the feed issues...

I'm not finding any specific 6.8 spring, so assume any short action should work... as long as it leaves the follower in a flatter position...

any suggestions on where to get an aftermarket spring, that might work better ???
 
Had the same problem with my Wyatts trigger guard/detatchable mag. I bent the top coil on the mag spring so it put a little pressure on the other end of the follower. Now it feeds all five rounds fine. Why mag manufacturers can't figure this out for themselves is beyond me.
 
thanks for the reply...my builder buddy didn't think the stock Remington spring would take to well to bending...

since springs aren't too expensive, I ordered 4 of them, a Savage, a Ruger, & a Browning, as well as another Remington spring, that didn't appear as "bent" in the picture ( though I realize it was a "stock" picture... anyway hope it looks more like the picture )... all 223 box magazine springs,
 
You must log in or register to reply here.
Back
Top