Geezerbiker
New member
I bought a 3/4HP bench grinder with a polishing wheel on one side from Harbor Freight to do some gun polishing. However it shakes like crazy and I wasn't able to get much done because I though it was going to shake everything off my bench.
Could it be that the wheel is out of balance? I took off the grind stone on the other side but it didn't make any difference. Is this something that might improve with wear?
When I took off the polishing wheel, the hole looked centered but I didn't think to run the motor unloaded at the time... I'll try that tomorrow.
Tony
Could it be that the wheel is out of balance? I took off the grind stone on the other side but it didn't make any difference. Is this something that might improve with wear?
When I took off the polishing wheel, the hole looked centered but I didn't think to run the motor unloaded at the time... I'll try that tomorrow.
Tony