Bear Grease

S

SteelChickenShooter

New member
Any adverse side effects to rubbing the Bear Grease brand leather dressing inside a "Hunter" brand holster? Right or wrong, my thinking is along the line of "ball glove" dressing- you know, something to make new, stiff leather more supple. And I like to darken the color of the unfinished edges as well as the inside. There is the problem. I don't and will not always wear this holster, so it will not break-in like normal. It will sit unused all year long until a few weeks for deer hunting comes along. The firearm is a stainless Ruger with a Hogue rubber grip upgrade. What do you guys say about spreading the conditioner inside the stiff, new leather holster? My guess is that it would be Ok. Since it's stainless steel, I'd expect any sort of oil or wax substance could readily be wiped off.
Your Toughts?
 
Don't use any grease or oil. Put your pistol in a plastic bag and then place it in your holster. Leave it their overnight, and when you are not wearing your holster. This should break in your holster normally.
 
Actually you want your holster to maintain a firm shape to properly hold the gun. There have been instances where a “supple” holster resulted in unintended discharge of the gun. There was a post on this forum where the holster bent or buckled or something and activated the trigger.
 
You do not want your holster soft and supple. The stiffness of the holster is what you need for proper retention.

Your holster will loosen up. Put your gun in it and let it sit for a few days. You can also wear it around the house for a few days too and that will help speed up the process.

Do not put any type of leather conditioner on your holster. While it might make it softer, it breaks down the fibers in the leather. This is not something you want.
 
Yeah, that Edge Kote looks good. All I want is to have the new dry holster look a little more worn and used than it is. I know about wearing a holster around the house for a while. I do that with other products but this Ruger is too big for doing that.
Bear is a tradename leather dressing grease and it's used for softening, preserving, and water-proofing hunting and work boots.
When first inserted, the Ruger was too long so the strap could not close. The holster was so stiff, the rear sights snagged. I had to flex the holster top quite a bit to make room for the rear sights to clear. After that I could shove that big 44 deeper to make the strap snap closed.
I like the idea of wrapping the revolver. I'll wrap some plastic around the back end so that rear sight can push the leather away leaving some sort of small gap. Thanks for the tips.
 
SteelChickenShooter - thanks for the info on Bear Grease. I read that as grease from a bear like that used in the old days of muzzle loading guns.
 
You must log in or register to reply here.
Back
Top