B-Square mount for GP-100

G

Glock_Racer

New member
I was thinking about purchasing a scope mount for my GP-100 6" and then mounting a red dot scope on it. B-Square makes one and no drilling and tapping is needed, just remove sights and install. Anybody have the B-Square mount installed on their GP-100 and does it hold up well?
 
I just installed the B-Square on my GP-100. It makes for a good, clean, solid mount. Very well designed.

Regards
 
Just ordered one from http://www.midwayusa.com along with a Tasco PDP3 "big dot" 25mm red dot scope. It'll arrive in 2 days. A range report with pics will follow. I will try and tackle 100yd. target...

Hey Bunkster, how hard was it to install the mount? Were the sights easy to remove?
 
From Glock_Racer: "Hey Bunkster, how hard was it to install the mount? Were the sights easy to remove?"

Using correctly sized screwdrivers and such, it was quite easy to do.

Removing both the front and rear sights presented no difficulty.

The B-Square mount was precisely machined. It fit each contour very well and layed "flat" upon all surfaces. I used blue Loctite on the two front mounting screws as well as the single screw on the rear.

Regards
 
You must log in or register to reply here.
Back
Top