A family member has an old BHP which is has frame and a slide that do not match. Slide serial number is 175XXX and has an internal extractor. The slide has an older adjustable sight. It is marked "micro" on the side which I believe is a older MMC aftermarket sight. The gun is a parts guns as far as I can tell but it has some sentimental value to the owner. I would like to help get it into working condition.
The gun was not zeroing so the owner was adjusting the height adjustment set screw and raised it as high as he could. Fired a few rounds and lost the screw and one of the springs. Anyone know what the thread was on these screws? I know a lot of set screws are 4-40? Also anywhere to get those springs or replacements?
Also does anyone know if it used a Novak cut for the rear sight?
It is not this gun but this is the sight that is on the gun and I believe the same front sight.
The gun was not zeroing so the owner was adjusting the height adjustment set screw and raised it as high as he could. Fired a few rounds and lost the screw and one of the springs. Anyone know what the thread was on these screws? I know a lot of set screws are 4-40? Also anywhere to get those springs or replacements?
Also does anyone know if it used a Novak cut for the rear sight?
It is not this gun but this is the sight that is on the gun and I believe the same front sight.
Last edited: