Another CZ-527m bedding job...

S

Sweet Shooter

New member
Hey guys... just sharing a new bedding job I did on my new 527. I did one of these a few years ago and it worked out okay so I wasn't too scared. However there's not a lot of room in this stock for resin and locking it in is a possibility- especially where the barrel enters the action (I filled that up with wax). I also put an aluminium pillar in the front action screw where you can see the wood already shows signs of compression. They use a roll-pin in the rear which works fine so I just left it and epoxied it in there. This is a .223 and shoots great anyway but the barrel was touching on the left of the channel at the end after a few rounds down range. I used Devcon 60 minute epoxy which is a perfect consistency for squeezing out. The 60 minutes also is good for working time. For a release agent I used Kiwi natural shoe polish which I've never had a problem with. I did have to rap on it a bit.

-SS-
 
Last edited:
Looks good. I did mine the hard way. I laid up a completely new stock with Carbon /Kevlar cloth and resin with aluminum bedding block.

CZcarbonkelvar2_zpsbb5a80a9.jpg


P90901464_zps5d36d8ac.jpg
 
@10-96- No that's what color it was... a dark gray (lighting wasn't too good).
@wachtelhund1 - That looks awesome. Is that dipped? Do you have build photos?
 
You must log in or register to reply here.
Back
Top