ammo feed in 10mm auto

O

oldscot3

New member
I'm looking at Double Tap's 200 gr. wide flat nose hard cast ammo in 10mm auto. I wonder if anyone has tried it and if they experienced feed issues or not?

My Witness, so far, eats everything, but that DT sure looks blunt to say the least.
 
Should feed just fine as long as the OAL is right. The rounded edge will see to that. Doesn't matter what cartridge it is either.
 
Thanks, I hate to spend a dollar a round for ammo that might have failure-to-feed issues. I guess DT casts their bullets, Montana Bullet Works offers a hard cast 200 gr. WFN that looks to have a very similar profile (no gas-check though). I may buy a box of them and hand load some to see how they feed in my Witness.
 
The rounded edge will see to that.
Click to expand...

Yep, but that's the source of my question. It's such a wide flat point, that it has very little taper to the end and a sharp rather than rounded edge. It's dang near a wad cutter.
 
I bought a box and hand loaded them and my Glock 20 did not like them. As you suspect, the WFN is getting hung on the feed ramp.

I also bought the 230 grain WFNGC and loaded those and they are fine. They have a more rounded nose profile.

I will vary by gun though, my M&P 40 shot them just fine.
 
Well, FWIW, I ran a box of those through my 10mm G40 without any problems, so maybe it's gun-specific? Don't know for sure, just suggesting. :confused:
 
You must log in or register to reply here.
Back
Top