9mm MV figures in Kahr?

J

Jhp147

New member
Does anyone have or have access to a link with info that will allow me to compare ACTUAL velocities of several different loads fired from a Kahr K9 or similar bbl. length? I am looking for 124 or 115s in +P vs. non +P loads, to see if there is any difference out of the short bbl.
Thanks
 
The following velocities are 10-shot averages from a Glock 26, which has a bbl comparable to your Kahr's:

Federal 124 gr Nyclad HP ~1063 ft/sec

Triton 115 gr +P JHP (Hi Vel) ~ 1280 ft.sec

Triton 125 gr +P JHP (Hi Vel) ~ 1245 ft.sec

Glaser Silver 70 gr Pre-Frag ~ 1514 ft/sec



Out of a Browning HP, these loads get:

Federal 124 gr Nyclad HP ~ 1079 ft/sec

Triton 115 gr +P JHP (Hi Vel) ~ 1332 ft.sec

Triton 125 gr +P JHP (Hi Vel) ~ 1281 ft/sec

Glaser Silver 70 gr Pre-Frag ~ 1534 ft/sec


Best.
 
Thanks, Stephen

Those Triton figures are pretty impressive.
Anybody got one on Federal 9mmBP vs. BPLE (115 vs.115+P), Gold Dots, or some other over the counter type load?
 
IIRC, 9BP would consistently break over 1100fps, and the BPLE would be get near to the 1300fps mark. FYI, the 90gr Cor-Bons would break into the low 1400fps range.:D BTW, this was with the full-size(irony) Kahr, not the MK series. :)
 
Here are some Cor-Bon (CB) and Triton (T) 115 gr velocities chrono'd thru my personal guns:

Marlin Camp 9 ~ CB-1536, T-1673

Glock 19 ~ CB-1348, T-1376

Glock 26 ~ CB-1308, T-1299

Kel-Tec P11 ~ CB-1249, T-1263
 
UNEDITED WHINY POST

Was gonna whine about velocities from SPECIFIC guns, but I didn't think it would do any good.

Oh heck, I'll try anyway.

The only velocity that matters is FROM YOUR GUN; matching pairs can be 200fps apart.

Continue.
 
You must log in or register to reply here.
Back
Top