870 action job?

B

Bullmoose

New member
Do 870's respond nicely to smoothing the action? My 2 stock ones work just great, but would like my tactical to be the best that it can be w/o trading it in on a $1000+ model from Wilson, Vang, etc... The only changes that I have made are adding a 2 shot mag extension on my 18", a tactical sling and I ordered a mount for a Red Dot that I already have thinking that it might be better both in low light and 100 yard slug scenarios that I will have taking the Front Sight course later this year. Any recommendations for a Orange Co, Ca smith? Thanks.
PS: any problems with an Express model compared to a Wingmaster so far as reliability?
 
Bullmoose, when I last visited the Vang website and looked at the decked out shotguns they sell, they start with the Express model...

There is no reason in my mind for believing that an Express model is somehow less reliable. I own an Express and a Police Magnum, and I keep the Express bedside, not the Police...
 
Run a coupla thousand rounds through that 870. It'll be smooth.

To speed things up, break it down as far as you can for cleaning. Go over all of the action bars and parts with a crockstick, turning those 90 degree angles into radiused ones. Clean obsessively and then lube with something like moly grease, wipe on/wipe off Karate Kid Style.

While you're in the middle of this, take the trigger group to a smith that is fecally cohesive and have HIM, not you, put a 3-4 lb trigger on it.

Reassemble, test fire and shuck it a few times. If still a little resistant, place one drop of CLP on the action bars where they enter the receiver and rack it a few times. Voila!! Your shotgun's done...
 
Musta needed a bit more coffee this AM. I left a step out...

Once you have the weapon apart, find the shiny wear marks and stone them with a hard Arkansas stone like machinists use, or use Jeweler's Rouge on a felt wheel to buff all the marks a bit. Then lube, and you'll have a slick shucker.
 
You must log in or register to reply here.
Back
Top