NEED ADVICE/MANUAL/INFO RE: DISASSEMBLY OF 50 BMG BOLT ON AMAC 5100.
THE SAFETY IS HANGING UP AT THE 1/2-ON POSITION CREATING A POTENTIAL FOR A DISCHARGE IF THE TRIGGER IS PULLED AND THEN THE SAFETY IS RELEASED. THIS IS VERY SCARY WITH A 750 GRAIN ROUND AT @2900FPS.
I CAN REMOVE THE BOLT SLEEVE WITH FIRING PIN AND SAFETY FROM THE BOLT.
1. AFTER REMOVING THE ALLLEN SCREW/SPRING/BEARING DETENT I CANNOT REMOVE THE SAFETY FROM THE BOLT SLEEVE HOUSING.
2. HOW DO I REMOVE THE FIRING PIN AND SPRING.
PLEASE HELP IF YOU HAVE ANY EXPERIENCE WITH THIS BOLT.
THE SAFETY IS HANGING UP AT THE 1/2-ON POSITION CREATING A POTENTIAL FOR A DISCHARGE IF THE TRIGGER IS PULLED AND THEN THE SAFETY IS RELEASED. THIS IS VERY SCARY WITH A 750 GRAIN ROUND AT @2900FPS.
I CAN REMOVE THE BOLT SLEEVE WITH FIRING PIN AND SAFETY FROM THE BOLT.
1. AFTER REMOVING THE ALLLEN SCREW/SPRING/BEARING DETENT I CANNOT REMOVE THE SAFETY FROM THE BOLT SLEEVE HOUSING.
2. HOW DO I REMOVE THE FIRING PIN AND SPRING.
PLEASE HELP IF YOU HAVE ANY EXPERIENCE WITH THIS BOLT.