I have a '47 Walker (Uberti) and everytime I remove the front frame to remove the cylinder for reloading, I find that no matter how hard I push the frame back on the two pins, I still end up using a rubber mallet on the muzzle to force the frame together so the wedge will fit back in. This cannot be normal procedure! I would have thought that after a lot of use, this would fit easier, but it doesn't. Anyone else have this issue? I can't see having to hammer the frame together each time you reload. Please advise...
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
'47 Walker
- Thread starter M14MSgt
- Start date
sundance44s
New member
I`ve always had to do the same with mine , and it`s an ASM made Walker .
I wasn`t going to complain about mine being that way ..Just glad it was still a tight fit .
I wasn`t going to complain about mine being that way ..Just glad it was still a tight fit .
Smokin_Gun
New member
It does sound like a good thing... I bet both you guys wedges fit right too.
MSGT...I'm in Palmdale, belong to Desert Marksmen Club.
Tryin' to talk Sundance into joinin...LoL!
SG
MSGT...I'm in Palmdale, belong to Desert Marksmen Club.
Tryin' to talk Sundance into joinin...LoL!
SG