Bucksnort1
New member
I am resizing 45ACP cases. I use a case gauge to periodically check for proper fit. I have two cases, one by S&B and the other a Federal that are not flush with the top of the gauge. They are below about 1/16".
Head space on semi-autos is determined by the mouth of the cartridge touching a ridge in the chamber. Both cases measure .884" - should be .898". These are at least once fired cases which I picked up at a range.
I will toss these two but out of curiosity, is there a danger in loading and shooting them?
Head space on semi-autos is determined by the mouth of the cartridge touching a ridge in the chamber. Both cases measure .884" - should be .898". These are at least once fired cases which I picked up at a range.
I will toss these two but out of curiosity, is there a danger in loading and shooting them?