I was setting up my forster co ax to load some 158grn Lead Semi Wad Cutters, When I set up my seating die , I didn’t screw the seating stem out far enough and I seated the bullet with just the tip protruding out of the end of the case. There is 3.5 grains of Bullseye Powder in there.
My question is would it be ok too shoot this out my S&W 586 not have to worry about it damaging something.
Again its not seated just a little too deep its alot too deep almost wad cutter deep. Its only 1, The rest are fine
My question is would it be ok too shoot this out my S&W 586 not have to worry about it damaging something.
Again its not seated just a little too deep its alot too deep almost wad cutter deep. Its only 1, The rest are fine
Last edited: