.22 lr file/trim die, make flat nosed bullets

M

moose fat

New member
Any one know where to get one of these dies?

I have been reading about making a 22 lr bullet a flat nose for a few years. Just read an article in "Guns" mag and have had no luck with my searches.
 
Thanks Hammerhead, exactly what I was looking for.

I looked on rimfire central and did a search, no results.
Google, Brownells and Midway no luck also.
 
Last edited:
I did this a number of years ago when I heard about it.

I used a short section of 1” bar stock, faced both ends in a lathe and drilled a hole down the center for the .22 round.

Made it like a case gauge but the bullet stuck out the end by he amount I wanted to trim off of it.

Waste of time but that’s how I did it.
 
You must log in or register to reply here.
Back
Top