1911 trigger prob.

K

kerry

New member
Hey, guys. I stripped my new Kimber down and cleaned it last night without a hitch. After reassimbling it I started noticing some take-up in the trigger that I hadn't noticed before. I didn't take the trigger assembly apart, just "field stripped" it. Could I have done something? And if so, can I correct it, or do I have to get a gunsmith? Other than the slack, the trigger seems as crisp as ever.
Thanks.
 
Nothing about a normal field stripping and cleaning should be able to change the trigger characteristics on a 1911 - with the only possible exception being the "freeing up" of the disconnector by lubing it. If the gun is not very old (read new to you) it may be that the slack just wasn't noticed before.

In either case, an adjustment to the take-up in the trigger would require a detailed strip of the lower and dimpling the trigger bow (Brownells sell a block and punch unit for this) or adjusting the bendable tab on some models. Either of these adjustments can cause a need for a re-fit of the grip safety since it repositions the rear of the trigger bow.

If you are handy around a 1911 and can totally disassemble (and reassemble) one, it can be done fairly easily. Otherwise, take it to a good smith if the trigger slack is just too much.

Mikey
 
Mikey,
Thanks for the info. I thought I knew that trigger pretty well before I took it out of the store, but then again I was excited. :)
Would you say that this is something I can have any "competent" gunsmith do, or do I need to send it out to a "super duper 1911 guru"?
Kerry
 
Kerry,
I own 5 kimbers and All of them have a certian amount of trigger "takeup". I wouldnt worry about it. All 1911's I have ever shot has it. without a little takeup, the trigger would be dangerous for carry. at least in my book it would.

------------------
10MM Magnum.... tried the rest, now I got the best
 
kerry,

Like 10mm says, a little slack is normal and OK. If it's too much, you can have it taken out or buy a trigger with the little adjustment tab.

I always take mine to a 1911 specialist or do it myself. I'm a real particular sort (picky old fart) so I'm willing to settle for the very best!

You have to make that decision for yourself...sorry. :)

Mikey
 
Kerry, I'm the guy u talked to about the police equipment I have for sale. My Kimber is the same after 500rds as it was new, as far as I can tell.
 
Kerry, I'm the guy u talked to about the police equipment I have for sale. My Kimber is the same after 500rds as it was new, as far as I can tell.
 
You must log in or register to reply here.
Back
Top