Old Dragoon
New member
I been busy today.
I didn't like my rammer latch dovetail at the 6 in. length. It was OK I suppose, but I didn't like it. So I cut the BBL back to 4 3/4 In. I will drill the bbl for the rammer latch and cut a slot in the bbl top for the front sight. Front sight will be an old silver dime or a similar shaped piece of silver. Shown below is a couple pictures of the mockup. Dime and rammer latch are taped on and the rammer is taped up.
Everything else is the way it'll be. Boy does this gun have balance. Hope to finish it this next week.
I didn't like my rammer latch dovetail at the 6 in. length. It was OK I suppose, but I didn't like it. So I cut the BBL back to 4 3/4 In. I will drill the bbl for the rammer latch and cut a slot in the bbl top for the front sight. Front sight will be an old silver dime or a similar shaped piece of silver. Shown below is a couple pictures of the mockup. Dime and rammer latch are taped on and the rammer is taped up.
Everything else is the way it'll be. Boy does this gun have balance. Hope to finish it this next week.